Northmere Scarp dual-arm alt-az mount, with carbon fiber tripod

Specifications

Description

The Scarp dual-arm mount is an alt-azimuth mount for refractors, short-tube reflectors, and ED binoculars on a tripod, rated for up to 8 kg. Two arms support the altitude axis on either side of the head, so the load is spread across a wider bearing than in single-arm designs. That reduces flex when you move the tube and keeps the view steadier at higher magnification. You aim the mount by hand in altitude and azimuth, the way you would point a camera.

Slow-motion rods on both axes allow fine corrections without touching the telescope. Each rod drives a fine-pitch gear, so a single turn moves the tube by a small fraction of a degree. Tension knobs on the altitude and azimuth axes set how freely the head moves. Tighten them for a firm hold in wind, or loosen them for quick sweeps across the sky. The mount has no motors, so you follow drifting objects by hand. That is manageable at low and medium power and at moderate magnification.

The saddle is a dual dovetail design that accepts bars up to 100 mm wide. A safety screw holds each bar while you tighten the main clamp. The head weighs 6.4 kg and has a standard 3/8-16 thread on its base for photo tripods and pier adapters. Keep the total load, including the tube, diagonal, eyepiece, and finder, well below the 8 kg rating, because heavier loads take longer to settle after focusing. Use a tripod rated for the same load so the setup stays steady.

Because the mount has no tracking, it suits visual sessions and daytime nature observing rather than long-exposure imaging. Setup takes a few minutes once the tripod is level.

About this configuration

Each configuration of the Northmere Scarp dual-arm alt-az mount uses the same mount head; the options change what it stands on and what ships with it. The carbon fiber tripod saves weight for travel while still damping vibration well at moderate magnification. Carbon fiber legs stay comfortable to handle on cold nights, since they conduct less heat away from your hands than metal. The fitted weather cover keeps dew and dust off the mount if you leave it set up between sessions.

The anodized black finish hides scratches and does not reflect the light of a red flashlight back at you. The 2023 edition uses the same gears and bearings as later years, with small differences in the clamps. Check the saddle type in the specifications against the dovetail bar on your telescope before you choose a configuration.

What's in the box

• Dual-arm alt-azimuth mount head with dual dovetail saddle
• Two slow-motion control rods
• Accessory tray
• Carbon fiber tripod with accessory tray
• Fitted weather cover

Compatibility notes

• Accepts dovetail bars up to 100 mm wide.
• The 3/8-16 base thread fits most photo tripods and pier adapters.
• Suits refractors and reflectors up to about 150 mm aperture and 6 kg for steady visual use.
• Not designed for tracking or long-exposure imaging.